Archive for the ‘Water Harvesting’ Category
ETo (Evapo Transpiration)
Greywater goes a lot further than you think!
The most important aspect of how much water is required to irrigate your garden is not the type of soil, but the climate of your region and the type of plants you want to grow.
This discussion does assume drip irrigation is used to water the garden, as it has the highest efficiency of all irrigation methods (it is also no more expensive than other methods such as branched drain and mulch basin irrigation.
Evapo Transpiration tells us how much water is required per month to properly account for soil moisture loss via plant growth and plant moisture evaporation.
An excellent ET guide is provided online by California Irrigation Management Systems (CIMIS).
The image above shows a section of an ETo chart for California.
Large images are available at the CIMIS website.
Contact your local garden shop or irrigator to find out the ETo value for your area.
The amount of rainfall per month is subtracted from the ETo to determine the monthly water shortfall (ie how much additional water is required).
The ETo value is an estimate of how much water is used by a well watered, full cover grass surface, 3-6 inches in height; used as a reference point for determining water use by other plant types through the application of a plant coefficient.
Plant Coefficient Plant Type
0.13 Very low water use
0.26 Low water use
0.45 Medium water use
0.65 High water use
Converting inches per month to gallons per month per sq ft
The ETo value represents inches per sq ft required per month, but we are working backwards – we need to know how far a certain amount of water will go for the month.
The multiplication factor is 0.62
(144 cubic inches per sq ft per inch of rain / 231 cubic inches per gallons)
Capillary Irrigation Efficiency
The ETo value is based on 100% irrigation efficiency. With standard spray irrigation, much water is lost to surface evaporation and overspray. Typically only 50% efficiency is achieved, so the calculated ETo value would be doubled to account for this.
Capillary Irrigation (mentioned earlier in this eBook) has a very high efficiency – over 90%.
The ETo rate should be multiplied by 1.1 to account for the 10% inefficiency.
The last step is to calculate the correct garden area that can be irrigated.
G = number of people x graywater per person, per day x 30
ET = Evapo Transpiration rate for your area.
R = Rainfall for the month being considered.
P = Plant coefficient
Irrigation area (sq ft) = G divided by ( (ET-R) x P x 0.62 x 1.1 )
The following shows the calculations made for Tucson, AZ.
ETo & Rainfall values for TUCSON, AZ
Inches required per month (medium water use)
Convert to Gallons per sq ft needed per month
Final value, based on 25 gallons per person per day
A 2 person household, with a graywater diversion and irrigation system, can grow a vigorous 470 sq ft garden space with medium water requirement plants, without any additional water during the hottest / driest months.
By selecting low water requirement plants, the area can be increased to 813 sq ft. Very low water requirement plants increase the area to 1,627 sq ft.
A 4 person household, with a graywater diversion and irrigation system, can grow a vigorous 705 sq ft garden space with medium water requirement plants, without any additional water during the hottest / driest months.
In all cases the garden space can be singular, or a group of smaller garden spaces adding up to the total amount.
To access our online calculator go to http://www.besthomewatersavers.com/pages/Graywater-Irrigation-Coverage-Calculator.html
The following is an article by Kenneth Davison, a senior journalist for ‘The Age’, a major daily newspaper for the city of Melbourne, Australia. It is a long article, but worth the read.
Melbourne is the capital of the state of Victoria, in south east Australia.
During the significant drought of the last 15 years, Melbourne’s water supplies dropped down to approximately 15% of reserves. The existing population of approximately 4 million is expected to almost double over the next 30 years. The desalination plant will only add 30% capacity, and by some estimates will only serve growth for the next 10 years.
I have added conversions / clarrifications in italics to assist non Australian readers. I have also bolded key points for speed readers. A list of you tube links is provided at the bottom of the article with interesting comments from officials / contractors etc.
May 31 / 2010
Victorians haven’t been told the full story on how much they could pay.
The Minister for Water, Tim Holding, has misled the electorate over the price of water from the Wonthaggi desalination plant, which will have the capacity to produce up to 40 per cent of Melbourne’s water.
Two years ago the retail price of water was 85¢ a kilolitre (250 gallons) when the price reflected the cost of dam water of about 40¢ a kilolitre, so that the average household paid about $800 a year for its water. Now households pay about $1000, even though they are using less under restrictions.
Tim Holding told Parliament on November 26 last year that the ”net present cost of water” over the 30-year life of the contract with AquaSure would be $1.37 a kilolitre (250 gallons), which means the price of water to households after the retail mark-up would be $2.20 a kilolitre in 2012 for an annual water bill of $2000.
So, on Holding’s own say-so, the price of water will double – meaning that most low-income families won’t be able to maintain a garden.
But Holding (and the Brumby government) hasn’t been telling the full story. The day after Holding’s announcement in the lower house, Greens upper house member Greg Barber asked Treasurer John Lenders (who represents Holding in the upper house): ”I gather that the $1.37-per-kilolitre amount may just have been a mathematically derived figure. Can the Treasurer explain what it means in terms of the price of water?”
Lenders responded: ”While the question is probably more appropriate for the Minister for Water, it is certainly one that I will get an answer for him.”
And the result? Nothing! There is no record of a response in Hansard and no record of a written response to Barber, according to Barber’s office.
The Coalition parties have apparently taken Holding at his word. They have shown no interest in the simple arithmetic behind the real price of water and the grossly misleading statement by Holding.
They apparently believe the wholesale price of water is $1.37 throughout the 30-year life of the contract. If so, the subsidy from the Victorian taxpayer will be billions of dollars just for the wholesale price.
The latest official estimated capital cost of the borrowings to finance the desal plant is $5.1 billion. This money has to be serviced and insured against default because, according to ASIC records, AquaSure appears to be a $12 company. Holding has said the government no longer guarantees the debt, so it must have given a ”take or pay” guarantee to take the water.
But at what price? On the most conservative assumption, AquaSure will have to pay 10 per cent on its borrowings repayable over 30 years. This means the annual repayments on capital alone are $537 million a year, or $3.58 a kilolitre. In other words, the $1.37-a-
kilolitre payment that Holding announced to Parliament doesn’t even cover the cost of capital.
But there’s more. The plant will cost just over $200 million a year to run, based on paying the premium for renewable energy as specified by the government – by coincidence, similar to the $1.37 claimed as the total cost by Holding.
No wonder there has been no response to Barber’s question. A meaningful answer would have revealed the actual wholesale cost of water supplied with green energy would be $4.90 – almost four times higher than Holding told Parliament. This converts to a retail price of $7.90, meaning the average household water bill will be about $3000 after the desal water is mixed with the dam water.
The only possible way the government could get the wholesale desal price down to $1.37 a kilolitre is if the government and Aquasure have made a novation agreement whereby Aquasure has inflated the capital requirement to finance a kickback to the government (via a side agreement with Melbourne Water) in order to reduce the price of water reported to Parliament for the first few years. This payment would be recouped later in the contract. To clarify this possibility, the whole contract with the numbers should be made public.
The standard claim of the Liberal Party is that it is the best party to manage the state’s finances. The Greens are denigrated as environmentalists who can’t add up. At least the Greens are numerate enough to smell a rat and sufficiently courageous to point out the emperor has no clothes.
There are other big issues that haven’t been explained. Why was Chloe Munroe, former deputy secretary of Treasury – which approves public private partnership deals – and more recently the secretary of Holding’s department responsible for water policy and water trading, appointed as chairman of AquaSure after AquaSure won the tender?
Further, Munroe is a commissioner of the National Water Commission, which advises governments including Victoria’s on water trading, and more recently has been appointed to the board of Hydro Tasmania, which could sell water to Victoria more cheaply than AquaSure.
Munroe’s appointments represent fundamental conflicts of interest.
Kenneth Davidson is an Age senior columnist.
Youtube videos of interest:
Lead Contractor agrees construction cost is 4.8 billion, not 3.5 billion.
Promotional video by Thiess (Contractor)
Victorian Government project launch
Visit our websites:
View our videos:
It is fascinating to correlate states that have commenced water harvesting code development (graywater and rainwater) against their population growth rates.
Here is a chart (from google.com) showing population growth over the last 30 years for selected states:
So while the population growth for the US averages about 1% per year (over the last 30 years), California had 54% growth, and Arizona 132% growth!
While there is scope for saving water in existing homes – currently Tucson residents average over 140 gallons per day in personal water use, compared to 40 gallons per day personal water use in places such as Melbourne, Australia, it will not be an easy path.
Aggressive water saving initiatives within the home will help – water efficient appliances, showers, change in habits etc; in warmer states over approximately 60% of personal water use is external (ie irrigating the garden, washing cars etc.
At some point authorities will have seriously tackle the water issue. The US economy relies on real growth, not debt growth, and will falter unless infrastructure can support the growth.
Certainly politicians are beginning to take note, with attempts to promote water re-use, although once the code actually hits the ground competing interests fight for turf.
Water Purveyors do need to sit back and work out how they are going to support this growth without massive impost on the consumer. Several purveyors now find they do not want water to be saved at the home – they need every drop to fulfill water reclamation contracts (ie water treatment) that are already in place. Examples of this are parts of Nevada and Arizona. This would be fanatastic if the reclaimed water was being used sensibly, however in many cases the water is simply re-used on golf courses and sporting grounds.
Even if the re-claimed water is presented back to the home, the intial sales pitch was your home could now have a guaranteed supply of water for the garden, at minimal cost. So instead of encouraging home owners to conserve this reclaimed water, the water purveyor wants them to use as much as possible, so they can improve the bottom line.
Drainage enginners don’t want you to use less water, because they are concerned you will be too efficient and cause flushing issues within the sewer and storm networks. It would make sense to design new subdivisions with this in mind. As I mentioned in the previous post, common sense and reality dont always come together.
If you live in one of the states listed on the chart, I recommend visiting your local water purveyor, and ask how they plan to cope with growth for the next 30 years, based on the past 30 years. Let me know what you find out. The many dicsussions I have had across the country are worrying.
What we do know is there is no more water to be found in the Colorado basin. Even if global warming is a non event, there will not be a 50%+ increase in rainfall over Western USA to support growth.
Hats off to Tucson Water and the City of Tucson. Their code requiring compulsory greywater stubouts on new houses is a great start. They have much more work to do developing a framework and impleneting the policy but they are on their way.
This blog is about extending the concept of water harvesting from simply rainwater harvesting, to harvesting all the water across the home.
Rainwater is extremely valuable, especially as water utilities start raising the price of water to cope with infrastructure upgrades required now, not just the future.
Relying on rainwater alone to help reduce water consumption in the home is risky business (unless you live a cool, moist environment). Over 60% of water use in the average American home is in the garden, and rainwater collection (and storage) can help supply this water.
However if you live in an area that has rainfall for 6 months of the year, and dry for the remaining six months, relying on a rainwater harvesting system can be very expensive.
Lets say your garden area requires 3,000 gallons of water per month for irrigation. Lets assume you have a six month dry period (It could be worse – San Diego has a 9 month dry period).
To ensure garden water supply from rainwater harvesting alone, the tank / cistern would need 6 x 3,000 gallons, or 18,000 gallons capacity. Apart from the expense involved (many thousands of $$), tanks / cisterns this size require a huge area, and land is expensive.
So the purpose of this blog is to explore the many different methods of water harvesting, such as rainwater harvesting, graywater (also know as gray water, greywater and grey water) re-use, reclaimed water, alternate water supplies; and most importantly place these methods into the appropriate context.
I promise to be straightforward and forthright in this blog. Water politics is not just confined to America, it is a world-wide phenomenon.
Water is a vital resource, second only to air, and as a result is big money. Vested interests include (but aren’t limited to):
– Water Utilities / purveyors
– Water fixture manufacturers
– Water treatment manufacturers and irrigators
– Water re-use designers and manufacturers (be kind – I am one of these!)
– Environmental quality jurisdictions
– Federal / State / City / Country code officials, planning consultants, and inspectors
– Plumbers / irrigators / landscapers
– and the most important stake holder of all; YOU.
I now have over 7 years of water re-use experience in Australia, and 2 years experience here in the US – at local, state and federal levels. Based on what I have learnt so far, the challenges facing America far outweigh those experienced in Australia.
The water / money relationship is much bigger in the US, and the stakeholders above all recognise the issues are serious, they just havent worked out how to work together on it yet. It is likely they will not come to agreement willingly, after all money is involved.
In the end, YOU, the consumer of water will ultimately drive how water is delivered to your home, how much you will pay for it, how you will use it (and re-use it, hopefully over and over again). You may not have control over how much you pay per gallon for water supply and sewerage disposal, but you will be able to control how much you potable water you consume.
Of even more concern to the regulators, is that YOU also decide whether to adhere to codes after the house is built, and they know code violations are everywhere. A pragmatic approach would be to develop codes that were sensible to the typical consumer, or change core infrastructure to cope with code violations.
In future posts, I will provide examples of how pragmatic solutions are rarely, if ever, found in the water regulation industry.
This primary focus of this blog is to raise awareness of what can be done, and what the impediments are. But it would be stupid of me not to promote two of my websites:
To read more about rainwater harvesting vs graywater go to: http://www.besthomewatersavers.com/pages/Rainwater-Guide.html